Husky H4210 Instruction Manual download pdf

Operation

Operating the cut-off tool

□ This 3” Cut-Off Tool is designed to operate on 90 PSIG.

Lower pressure (below 90 PSIG) will reduce performance

of the tool. Higher air pressure (over 90 PSIG) raises the

performance of the tool beyond its rated capacity and

could cause serious damage to the tool and the user.

□ Push the safety bar and press the lever to operate.

Installing the cut-off wheels

WARNING: Disconnect the tool from the air supply before

servicing or changing accessories.

□ Only use 3” diameter cut-off wheels rated at 20000 RPM or

higher.

□ Fit the wheel over the spindle on the front of the cut-off

tool, use the spanner wrench (B) to hold the spindle and

tighten the lock nut disc with the hex key wrench (C).

Removing the cut-off wheels

WARNING: Disconnect the tool from the air supply before

servicing or changing accessories.

□ Remove the air supply from the cut-off tool.

□ Use the spanner wrench (B) to hold the spindle, loosen the

lock nut disc with the hex key wrench (C) and remove the

cutting disc.

Cutting plastic and metal

□ Connect the cut-off tool to the air supply.

□ Hold the cut-off tool in one hand and start the rotation by

operating the throttle lever.

□ Place the cut-off wheel on the work area and gradually

apply pressure to achieve the desired cutting speed and

depth.

6 Operation1 Operating the cut-off tool □ This 3” Cut-Off Tool is designed to operate on 90 PSIG. Lower pressure (below 90 PSIG) will reduce performa

No comments

Husky H4210 Instruction Manual