6
Operation
1
Operating the spray gun
□ This air operated spray gun is designed to perform a
variety of painting, coating, and nishing applications using
the power of compressor air.
□ Do not exceed the maximum air pressure of 45 psi.
□ The trigger lever of this gun has a two-step design. Press
the trigger lever to the rst step to connect to the air
source, ensuring that air ow lls the spray gun. Press
the trigger lever to the second step to connect the paint
material.
2
Controlling the pattern and uid ow
□ Adjust the air pressure with the trigger pulled. If reduced
air pressure is desired for some areas of the spray job,
use the air compressor regulator to reduce pressure as
necessary.
□ Set the pattern size to the desired shape. For a full pattern,
turn the pattern control knob counterclockwise. For a
round pattern, turn the pattern control knob clockwise.
□ Turn the uid control clockwise to reduce uid and counter
clockwise to increase uid.
□ The direction of the fan (horizontal or vertical) can be
adjusted by loosening the air cap ring and turning the air
cap 90 degrees.
□ Trigger a short burst while turning the uid control knob
counterclockwise. Observe the spray pattern on the
target and adjust the uid control knob until the desired
atomization is achieved.
Air Cap
(1)
Air Cap Ring
(2)
Horizontal Fan
(3)
Vertical Fan
(4)
4
1
2
3
Pattern Control
Knob
(1)
Fluid Control
Knob
(2)
1
2
Comments to this Manuals