Husky C803H Use and Care Manual download pdf (Page 18)

Air compressor Head

Bolts - Torquing

The air compressor pump head bolts should

be kept properly torqued. Check the torques

of the head bolts after the rst ve hours of

operation.

Torque to 14–16ft.-lbs. (19.0–21.7 Nm).

Additional Service

Disassembly or service of the air compressor

beyond what is covered in this manual is

not recommended. If additional service is

required, contact 1-888-43-HUSKY for further

assistance.

Maintenance (continued)

Storage

Before you store the air compressor, make

sure you do the following:

1. Review the Maintenance section

on the preceding pages and perform

scheduled maintenance as necessary.

2. Drain water from air tank. See To Drain

Tank under Operation.

WARNING: Water will condense

in the air tank. If not drained,

water will corrode and weaken

the air tank causing a risk of air

tank rupture.

Troubleshooting

Problem Possible Cause Solution

Compressor does

not run.

Tank has insufcient

pressure.

When the tank pressure drops, the

compressor will turn on to cut-in

pressure.

No electrical power. Verify wiring connection inside

pressure switch and terminal box

area.

Blown shop/house fuse. Replace the shop/house fuse.

Tripped shop/home

breaker.

Reset the shop/home breaker and

determine the underlying cause.

Thermal overload is open. Place the Auto/Off switch in the

“Off” position.

Allow the motor to cool.

Depress the red reset button on

the motor.

Place the Auto/Off switch in the

“Auto” postion to restart the

motor.

Loss of power or

overheating.

Verify wiring.

NOTE: Long lengths of electrical

wiring could cause power loss to

the motor.

Pressure switch is bad. Replace the pressure switch.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 83 84

Comments to this Manuals

No comments

Husky C803H Use and Care Manual Page 18

Comments to this Manuals

Related products and manuals for Air compressors Husky C803H