Husky L13HPD Use and Care Manual download pdf (Page 6)

Safety Information (continued)

ELECTRICAL SAFETY (SPEED AND WIRING)

□ The no-load speed of this product is approximately

1,700 rpm. This speed is not constant and

decreases under a load or with lower voltage.

□ For voltage, the wiring in a shop is as important as

the motor’s horsepower rating. A line intended only

for lights cannot properly carry a power tool motor.

Wire that is heavy enough for a short distance will

be too light for a greater distance. A line that can

support one power tool may not be able to support

two or three products.

ELECTRICAL SAFETY (GROUNDING

INSTRUCTIONS)

□ This product must be grounded. In the event of an

electrical short circuit, grounding reduces the risk

of electric shock by providing an escape wire for

the electric current. This product is equipped with

a cord having a grounding wire with an appropriate

grounding plug. The plug must be plugged into an

outlet that is properly installed and grounded in

accordance with all local codes and ordinances.

WARNING: Improper installation of the grounding plug

may result in a risk of electric shock. When repair or

replacement of the cord or plug is required, do not connect

the grounding wire to either flat blade terminal. The wire

with insulation having an outer surface that is green with

or without yellow stripes is the grounding wire.

□ Check with a qualified electrician or service

personnel if these instructions are not completely

understood or if in doubt as to whether the tool is

properly grounded.

□ Do not modify the plug provided; if it will not fit

the outlet, have the proper outlet installed by a

qualified electrician.

□ This product is for use on a nominal 120-Volt

circuit and has a grounding plug similar to the

plug shown. Only connect the product to an outlet

having the same configuration as the plug. Do not

use an adapter with this product.

GROUNDING PIN

120-Volt GROUNDED OUTLET

1 2 3 4 5 6 7 8 9 10 11 ... 24 25

No comments

Husky L13HPD Use and Care Manual Page 6