Husky 9045733 Use and Care Manual download pdf (Page 16)

WARNING:

When servicing, use only identical Husky replacement

parts. Use of any other parts may create a hazard or

cause product damage.

WARNING:

Always wear safety goggles or safety glasses with side

shields during power tool operation or when blowing

dust. If operation is dusty, also wear a dust mask.

WARNING:

Always release all pressure, disconnect from power

supply, and allow unit to cool to the touch before

cleaning or making repairs on the air compressor.

MAINTENANCE

GENERAL MAINTENANCE

Humidity in the air causes condensate to form in the air

tank. This condensate should be drained daily and/or

every hour, using the instructions found in Draining the

Tank.

The safety valve automatically releases air if the air

receiver pressure exceeds the preset maximum. Check

the safety valve before each use following the instructions

found in Checking the Safety Valve.

Inspect the tank yearly for rust, pin holes, or other

imperfections that could cause it to become unsafe.

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil, grease, etc.

LUBRICATION

All the bearings in this tool are lubricated with a sufficient

amount of high grade lubricant for the life of the unit

under normal operating conditions. Therefore, no further

lubrication of the bearings is required.

WARNING:

Do not at any time let brake ﬂ uids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemical can damage, weaken or

destroy plastic which may result in serious personal

injury. Electric tools used on ﬁ berglass material, wall-

board, spackling compounds, or plaster are subject

to accelerated wear and possible premature failure

because the ﬁ berglass chips and grindings are highly

abrasive to bearings, brushes, commutators, etc.

Consequently, we do not recommend using this tool for

extended work on these type of materials. However, if

you do work with any of these materials, it is extremely

important to clean the tool using compressed air.

OVERLOAD PROTECTOR

This air compressor is equipped with a thermal overload

device which will turn the air compressor off automatically,

if the air compressor becomes overheated. If the motor

turns OFF repeatedly, check for the following possible

causes first: Low Voltage from the outlet. Lack of proper

ventilation or outside air or room temperature too high.

Extension cord too long or wrong gauge wire used.

To reset the air compressor:

Turn the air compressor off.

Unplug the air compressor, and allow it to cool for 30

minutes.

Plug the air compressor into an approved outlet.

Turn the air compressor on.

OPERATION

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Comments to this Manuals

No comments

Husky 9045733 Use and Care Manual Page 16

Comments to this Manuals

Related products and manuals for Air compressors Husky 9045733