Husky VT6314 Use and Care Manual download pdf (Page 14)

Installation - Electrical (continued)

Preparing the pressure switch

□ Remove the pressure switch cover by loosening the

screw (1), as shown. Use a Phillips screwdriver.

□ Set the cover aside until wiring is completed.

□ Familiarize yourself with these internal components of the

pressure switch.

□ Refer to the illustration below to identify the motor terminal

(2), line terminal (3), ground screw (4), and ground line (5).

Making the electrical connections

□ Remove the ground screw (1). Install the strain relief on the

pressure switch (2). Do not tighten the strain relief on the

power cord until wiring is complete. Insert the bare wires

[black, white, bare/green](3, 4, 5) through the strain relief.

□ Attach the bare/green ground wire (5) ﬁ rst to the ground

screw (1) on the pressure switch body.

□ Look for the “Line” markings on the pressure switch. Install

the line wires (3, 4) and tighten the terminal screws (6).

3 4

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

Husky VT6314 Use and Care Manual Page 14