Husky VT6314 Use and Care Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
19 HUSKYTOOLS.COM
Please contact 1-888-43-HUSKY for further assistance.
Maintenance
GENERAL MAINTENACE
All repairs should be performed by an authorized service representative.
WARNING: Disconnect, tag, and lock out the power
source, and then release all pressure from the system
before attempting to install, service, relocate, or perform
any maintenance.
1
Checking and changing the oil
Maintain the proper oil level by checking the oil sight glass (1)
daily. Change the oil in the pump every 3 months. Use the following
procedure to change (or add) oil.
Run the compressor for ten minutes to warm up the oil if the
unit has not been in use for an extended period of time.
Turn the compressor off and disconnect the compressor
from the power source.
Position a pan under the pump drain plug (2) to catch the oil.
Remove the pump drain plug (2) and allow the oil to collect
in the pan.
Reinsert the oil drain plug. Remove the breather (3) from the
pump. Pour new, unused oil into the pump. Do not overfi ll.
Reinsert the breather (3) into position. Return power to the
compressor for use.
2
Checking the ASME safety valve
Run the air compressor until it reaches cut-out pressure.
Turn the compressor off and disconnect the compressor
from the power source.
Put on safety glasses. Protect yourself from fast moving air.
Pull on the ring of the ASME safety valve (1). This
releases pressure from the tank. The safety valve should
automatically close at approximately 40 - 50 psi.
If the safety valve does not allow air to be released when you
pull on the ring, or if it does not close automatically, it MUST be
replaced.
3
Draining the tank of moisture
Turn the compressor off and disconnect it from the power
source.
Release the pressure from the compressor by pulling on
the ASME safety valve. The ASME safety valve should close
at approximately 40 - 50 psi.
Open the drain valve (1) underneath the tank. Remaining
air pressure will assist in removing moisture from the tank.
2
1
3
1
1
Page view 18
1 ... 18 19 20 ... 28

Comments to this Manuals

No comments